• Model: IRL-B4-1 + B4-3
  • Manufactured by: Rodtech UK


€55.90
€51.99 Ex VAT
Saving: €3.91

€63.94 Inc VAT

Add to Cart:

Twin Scraper pack Click

Be prepared by having the set of scrapers at a reduced price. The 150 x 100 mm (6” x 4”) flat scraper designed by chimney sweeps will fit neatly into your tool bag and unlike other scrapers on the market is flat. It will scrape soot off register plates and scrape tar from chimneys. It is heavy enough that by dragging it along the surface of a register plate it should not lift over the soot and tar, but stays seated on the surface and collects the waste with minimum of fuss. For smaller gaps (particularly round the flue pipe) turn on its side and use as a 100 mm (4”) scraper. The 270 x 100 mm (10 ¾” x 4”)flat angled scraper has been specifically designed for the heavily neglected dirty register plate which you will have the misfortune to get called out to clean. Designed by sweeps to fit onto ButtonLok rods. It has been shaped so that the back edge is 100 mm wide with two further 100mm edges at 30 degree angles. This scraper is designed with its angles so that you can scrape large quantities of soot from register plates and can also scrape tar from chimneys. It is heavy enough that by dragging it along the surface of a register plate it should not lift over the soot and tar, but will stay seated on the surface and collect large quantities of waste with minimum of fuss. For smaller gaps (particularly round the flue pipe) turn on its side and use this as a 100 mm (4”) scraper, as you would a hoe.


  • Model: IRL-B4-1 + B4-3
  • Manufactured by: Rodtech UK

Add to Cart: